Table of Contents
Advertisement
Steps
1. Place the display panel on a flat and clean surface .
2. Connect the display cable to the connector at the back of the display panel and close the latch to secure the cable .
3. Adhere the tape that secures the display cable to the back of the display panel .
4. Turn the display panel over and place it on the display back-cover .
5. Replace the six (M2x2.5) and two (M2.5x2.5) screws that secure the display panel to the display back-cover.
Next steps
1. Install the
display
bezel.
2. Install the
display
assembly.
3. Install the WLAN.
4. Install the battery.
5. Install the
base
cover.
6. Install the
SD
card.
7. Follow the procedure in
Camera
Removing the camera
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Disconnect the
battery
5. Remove the WLAN.
6. Remove the
display
assembly.
7. Remove the
display
bezel.
8. Remove the
display
panel.
About this task
after working inside your
before working inside your
cable.
computer.
computer.
Disassembly and reassembly
63
Advertisement
Table of Contents
