Dell 3100cn Color Laser Printer User Manual page 149
User's guide
Hide thumbs
Also See for 3100cn Color Laser Printer:
- Setup manual (2 pages) ,
- Owner's manual (90 pages)
Table of Contents
Advertisement
NOTE:
Do not continue with this procedure until you have the following three addresses:
- IP Address
- Subnet Mask Address
- Gateway Address
For more information on using your operator panel, see
1. Turn on the printer.
The Ready to Print appears.
2. Press Menu.
3. Press
until Configure appears, and then press
4. Press
until Network appears, and then press
5. Press
until TCP/IP appears, and then press
6. Press
until IP AddressSetup appears, and then press
7. Press
until Panel appears, and then press
8. Press
.
9. Press
until IP Address appears, and then press
10. The cursor is located at the first digit of the IP address. Press
11. Press
.
The cursor moves to the next digit.
12. Repeat steps 10 and 11 to enter all of the digits in the IP address, and then press
13. Press
.
14. Press
until Subnet Mask appears, and then press
15. Repeat steps 10 to 11 to set Subnet Mask, and then press
16. Press
.
17. Press
until Gateway Address appears, and then press
18. Repeat steps 10 to 11 to set Gateway Address, and then press
19. Turn off the printer, and then turn it on again.
The IP address is assigned to your printer. You can verify the setting by opening the web browser on any computer on the network and enter the IP address
into the URL line. If the IP address is set up correctly, the Dell Printer Configuration Web Tool displays in your browser.
You can also assign the IP address to the printer when installing the printer drivers with installer. When you use the Network Installation feature, and the IP
AddressSetup is set to AutoIP on the operator panel menu, you can set the IP address from 0.0.0.0 to the desired IP address on the printer selection window.
Verify the IP Settings
1. Print another Printer Settings page.
2. Look under the TCP/IP heading on the Printer Settings page to make sure the IP address, netmask, and gateway are what you expected.
or
Ping the printer and verify that it responds. For example, at a command prompt on a network computer, type ping followed by the new printer IP
address (for example, 192.168.0.11):
ping 192.168.0.11
If the printer is active on the network, you will receive a reply.
"Operator
Panel."
or
.
or
.
or
.
or
.
.
or
.
to enter the numbers for the IP address.
or
.
.
or
.
.
.
- Quick Links:
- Printer Settings
Hide quick links:
Advertisement
Chapters
Table of Contents
